ADIC Scalar 100 User Manual page 277

If the ridtag command is entered with a string, that string becomes the RID tag
recorded for the unit.
Gateway > ridtag "12D345677"
*** value = 0 = 0x0
If a string is not entered, the existing RID tag is displayed.
Gateway > ridtag
RID Tag = 12D345677
value = 0 = 0x0
Gateway >
On original equipment, the RID tag will be blank.
rm
To remove a file, use the rm command and specify the file name in quotes:
Gateway > rm "file.ext"
route
The route utilities maintain a route file, ffs:/mgmt/route, which is used at
system startup to initialize the network routing table. Each route entry is a single
line of the format:
destination:gateway
where
An IP address is a text string in standard IP Address format (i.e., 10.0.0.2). A host
or gateway name must be listed in the hosts file.
Here is an example of the contents of the route file.
socrates:bruno
10.0.0:bruno
The first line instructs the system to reach the host "socrates" by directing the IP
packets to the host "bruno". The second example shows how all traffic for the
rm
destination
gateway
is an IP address (for a subnet or host) or the
name of a host that is described in the
hosts file.
is an IP address or the name of a gateway to
a host. The gateway must be a device on
the local subnet.
261