ADIC Scalar 100 User Manual page 66

Set the host name:
The host name is set using the hostNameSet command. In the example shown,
the host name of the ADIC Gateway was "Gateway" and is now being set to
"foster." The shell prompt will change to reflect the new name.
Gateway > hostNameSet "foster"
Target hostname set to foster
value = 0 = 0x0
foster >
Set the host network address:
The network address is set using the ethAddrSet command. The IP address is
specified as four decimal numbers, separated by periods.
foster > ethAddrSet "192.168.1.54"
Host Address set to 192.168.1.54 for Ethernet interface
value = 0 = 0x0
If you need to set a netmask, specify it after the network address:
foster > ethAddrSet "10.0.0.2", "255.0.0.0"
Set the network routes and/or default gateway:
If a network gateway is needed for the ADIC Gateway to communicate with other
systems, you must specify one.
foster > gateAddrSet "192.168.1.1"
value = 0 = 0x0
When more complicated routing is required to reach the ADIC Management
Console server, use the route command to specify the destination address, as a
full address (single host) or as an abbreviated subnet address, and specify the
address of the gateway that is reachable on the local subnet.
foster > route "add", "206.0.0", "192.168.1.1"
value = 0 = 0x0
foster >
Add User Account for Telnet (optional):
If you want to access the ADIC Gateway's command line interface through its
Ethernet port using a Telnet session, you need to add a user account. In the
example below, specify the desired user name and user password. The user that
you specify must be 3 or more characters and the password you specify must be
50
ADIC Gateway Network Setup