ADIC Scalar 100 User Manual page 292

snmpTrapCommunitySet string
" "
The snmpTrapCommunitySet command sets the community string passed with
all SNMP traps.
Gateway > snmpTrapCommunitySet "DISC Inc."
Success
value = 8 = 0x8
Gateway >
snmpWriteCommunityAdd string
" "
The snmpWriteCommunityAdd command adds the specified string to the list of
accepted strings for SNMP Write operations (Set).
Gateway > snmpWriteCommunityAdd "DISC"
Success
value = 0 = 0x0
Gateway >
snmpWriteCommunityRemove string
" "
The snmpWriteCommunityRemove command removes the specified string from
the list of accepted strings for SNMP Write operations.
Gateway > snmpWriteCommunityRemove "DISC"
Success
value = 0 = 0x0
Gateway >
sysConfigShow
The sysConfigShow command displays current system parameter settings. The
display shows whether or not the ADIC Gateway Command and Control interface
is enabled or disabled and the LUN that is assigned to it, whether or not enhanced
tape performance features are enabled, the MAC address of the Ethernet port;
and the ADIC Gateway Fibre Channel Node address.
Gateway > sysConfigShow
Current System Parameter Settings:
Command and Control Device (CC) : 0 Enabled
LUN : 0
Allow Early Write Status for Tape : 1 Enabled
Allow R/W Acceleration for Tape : 1 Enabled
Enet MAC Address: 0.60.45.16.1.4
FC Node WWN: 10000060.45160104
value = 0 = 0x0
Gateway >
276
snmpTrapCommunitySet "string"