ADIC Scalar 100 User Manual page 266

value = 0 = 0x0
Gateway >
icmpstatShow
The icmpstatShow command displays ICMP statistics for the Ethernet network.
Interpreting these statistics requires detailed knowledge of Internet networking
protocols. This information may be useful to the LAN administrator.
Gateway > icmpstatShow
ICMP:
0 call to icmp_error
0 error not generated because old message was icmp
0 message with bad code fields
0 message < minimum length
0 bad checksum
0 message with bad length
Input histogram:
0 message response generated
value = 30 = 0x1e
Gateway >
ifShow
The ifShow command is used to show the Ethernet port parameters and status
as shown below. The ADIC Gateway will show two devices. lnPci is the Ethernet
port. lo is the local loopback port.
Gateway > ifShow
lnPci (unit number 0):
Flags: (0x63) UP BROADCAST ARP RUNNING
Internet address: 192.168.1.54
Broadcast address: 192.168.1.255
Netmask 0xffffff00 Subnetmask 0xffffff00
Ethernet address is 00:60:45:0d:00:c0
Metric is 0
Maximum Transfer Unit size is 1500
13 packets received; 12 packets sent
0 input errors; 0 output errors
0 collisions
lo (unit number 0):
Flags: (0x69) UP LOOPBACK ARP RUNNING
Internet address: 127.0.0.1
Netmask 0xff000000 Subnetmask 0xff000000
Metric is 0
Maximum Transfer Unit size is 4096
4 packets received; 4 packets sent
250
destination unreachable: 1
icmpstatShow