Table 3-1: Pre-Installation Steps
Step
7
8
9
Pre-installation Checklist
User Action or Decision
Ensure that SCSI disk or
tape system installation
has been completed.
•
For tape attach, tape
device driver installed or
updated
•
Mark both ends of each
SCSI cable with
-Target ID and
channel number
-ADIC Gateway ID
and channel number
Decide on network
parameters.
Ethernet port configuration
decisions:
•
Static IP
address____________
•
Netmask (if
required)_________
User-defined ADIC
•
Gateway name
(optional)_______________
If the ADIC Gateway is not
on the same TCP/IP
subnet as the server*,
assign the default network
gateway address and/or
route table entries.
_____________________
Attention: Save this
configuration information
for future reference.
Run the Ethernet cable
from the ADIC
Management Console
server to the network hub
Comments and References
Usually done by you or a service
representative during target device
installation
Obtain the network parameters from your
network administrator.
Attention: Use of incorrect network
parameters can cause problems on the
Ethernet network.
The default network name is ADIC
Gateway. If you choose a different name,
it becomes the prompt displayed on the
service terminal. Choosing a different
name may be useful if you have more
than one ADIC Gateway
None
31