Check For Problems On Attached Scsi Devices; Check Fc Host Versions; Check Adic Gateway Product Versions - ADIC Scalar 100 User Manual

Check for Problems on Attached SCSI Devices

Check the following on the SCSI devices to determine whether they are the
source of the problem:

Check FC Host Versions

For an updated list of supported ADIC Gateway host platforms and Fibre Channel
Host Bus Adapters, visit "Service and Support" at www.adic.com, or call the ADIC
Technical Assistance Center at 1-800-827-3822.
You'll need to determine the following:
If an update is required, perform the update.

Check ADIC Gateway Product Versions

For an updated list of required updates, visit "Service and Support" at
www.adic.com, or call the ADIC Technical Assistance Center at 1-800-827-3822.
1. If the ADIC Management Console application is in use, use the
menu in the ADIC Management Console to determine its software version. If
an update is needed, download the update from the Web site and perform the
update.
2. To check the firmware version, start the ADIC Management Console and
connect to the ADIC Gateway. When the initial Tree View appears, choose the
ADIC Gateway and then read the firmware version from the right-hand panel
of the display.
If the client application is not available, use the version command from the
service terminal to determine the firmware version (see the "version"
command on page 283. If an update is required, download the update from
the Web site and perform the update.
158
• LEDs
• Display panels
• Firmware levels
• Operability
• Operating system version
• Service pack version
• Hot-fix version
• HBA hardware version
• HBA firmware version
• HBA device driver version
Help > About
Start MAP