key was factory installed, VPM is already enabled. See also the licenseShow
command.
Router> vpmFeatureEnable "H822F-KCRV2"
value = 0 = 0x0
Router >
vpsAccessApply
The vpsAccessApply command causes the settings that have been changed
and stored in memory to take effect immediately and also saves them to the VPS
database.
vpsAccessClear [disable code]
The vpsAccessClear command disables all host access to all LUNs except to
LUN 0 (the Command and Control interface). The disable code is 0xfacade02.
The following command example shows how to disable all access.
Gateway >vpsAccessClear 0xfacade02
value = 0 = 0x0
Gateway >
vpsAccessSet [hostindex],<Starting LUN>,<Ending
LUN>,<Access>
The vpsAccessSet command sets the access for the specified range of LUNs
for the specified host connection index. Existing hostindex values can be
determined by looking at the "Id" column in the output of the vpsShow -1
command (see page 287).
When you enter this command, the settings are stored in memory but are not
applied until you enter the vpsAccessApply command. The following example
shows how to enable the host at connection index 1 to access LUNs 2 through 32.
Gateway > vpsAccessSet 1,2,32,1
value = 0 = 0x0
Gateway >
284
Access
0
Disables access to the LUNs
1
Enables access to the LUNs
vpsAccessApply