ADIC Scalar 100 User Manual page 301

vpsActiveSet
The vpsActiveSet command places VPS in the active state. The means that all
of the current access settings are put into effect. You would typically only use this
command after making VPS inactive. See the vpsInactiveSet command.
Gateway > vpsActiveSet
value = 0 = 0x0
Gateway >
If VPS is already active, the following is displayed.
Gateway > vpsActiveSet
VPS: Already Active
value = 21 = 0x15
Gateway >
vpsConnectionSet [hostindex], host connection string
" "
The vpsConnectionSet command sets the host connection information for the
host at the specified connection index. The connection may be a device name,
port address, etc. The following example shows setting the host connection
information. Existing hostindex values can be determined by looking at the "Id"
column in the output of the vpsShow -1 command.
Gateway > vpsConnectionSet 1,"ScsiPort2 [0:0:0] (QLA2100)"
value = 0 = 0x0
Gateway >
vpsFeatureEnable license key string
" "
The vpsFeatureEnable command enables the VPS feature. Each license key
is unique for each ADIC Gateway serial number. If the feature is factory-enabled
you can specify "enable" rather than an actual license key.
vpsHelp
The vpsHelp command displays a list of the Virtual Private SAN commands.
Gateway > vpsHelp
vpsAccessApply
vpsAccessClear <disable code>
vpsAccessSet [host index],<starting lun>,<ending lun>,<access>
vpsActiveSet
vpsConnectionSet [host index],"host connection string"
vpsFeatureEnable "license key string"
vpsHostShow [host index]
285
vpsActiveSet