Potential Safety Hazard Areas; Build Chamber; Z Stage; Door Locks - Stratasys Origin One User Manual

Safety Instructions

Potential Safety Hazard Areas

The following components and areas of the printer are highlighted as potential safety hazards
that may cause system failure or reliability problems if proper safety procedures are not
followed.

Build Chamber

Z Stage

Door Locks

A reed switch is used to communicate the status of the build chamber door. The build chamber
door interlocks must be disabled on the printer user interface (UI) before the door can be
opened. Z stage motion is possible with the build chamber door open. Use caution when
accessing the build chamber.

General Safety Practices

Abide by these general safety practices when working with this printer.
Warning: Hot Surfaces.
Always wear safety gloves and long sleeves when working inside the oven.
Components are hot.
Warning: Moving Parts.
Never wear a tie, loose clothing or dangling jewelry when working around moving
components of the printer.
Keep hands clear of the area between the build head and the resin tray/glass while
the printer is powered on.
Warning: High Voltage.
High voltage is present in the printer.
Warning: Falling Hazard.
Only use an OSHA or CE approved step stool when accessing the area under the
top cover of the printer.
Warning: Hot Surfaces.
Always wear safety gloves and long sleeves when working inside the oven.
Components are hot.
© Copyright 2022 Stratasys. All rights reserved.
Potential Safety Hazard Areas
Page 6