default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
Format
default-metric <0-15>
Mode
Router RIP Config
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Format
no default-metric
Mode
Router RIP Config
distance rip
This command sets the route preference value of RIP in the router. Lower route preference
values are preferred when determining the best route. A route with a preference of 255
cannot be used to forward traffic.
Default
15
Format
distance rip <1-255>
Mode
Router RIP Config
no distance rip
This command sets the default route preference value of RIP in the router.
Format
no distance rip
Mode
Router RIP Config
distribute-list out (RIP)
This command is used to specify the access list to filter routes received from the source
protocol.
Default
0
Format
distribute-list <1-199> out {ospf | static | connected}
Mode
Router RIP Config
ProSafe Managed Switch
Routing Commands
309