Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
14.7.6.1 no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Format
Mode
14.7.7 distance rip
This command sets the route preference value of RIP in the router. Lower route preference
values are preferred when determining the best route.
Default
Format
Mode
14.7.7.1 no distance rip
This command sets the default route preference value of RIP in the router.
Format
Mode
14.7.8 distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Default
Format
Mode
14.7.8.1 no distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Format
Mode
Routing Commands
no default-metric
Router RIP Config
15
distance rip <1-255>
Router RIP Config
no distance rip
Router RIP Config
0
distribute-list <1-199> out {ospf | bgp | static |
connected}
Router RIP Config
no distribute-list <1-199> out {ospf | bgp |
static | connected}
Router RIP Config
v1.0, March 2006
14-61