Table of Contents
Advertisement
REVISION HISTORY
Rev.
Date
1.20
Nov 01, 2005
R8C/18 Group, R8C/19 Group Hardware
Page
18
Table 4.3 SFR Information(3);
0085h:
0086h:
0087h:
008Ch:
008Dh:
0090h, 0091h: "Timer C" → "Timer C Register" revised
36
Table 6.16 Port XIN/P4_6, XOUT/P4_7 Setting;
Setting value
CM1: "1" → "0", CM0: "0" → "1", Feedback resistance: "OFF" → "ON",
37
Table 6.18 Unassigned Pin Handling, Figure 6.9 Unassigned Pin
Handling;
"Port P4_2, P4_6, P4_7" → "Port P4_6, P4_7"
"VREF" → "Port P4_2/VREF" revised
51
Table 9.2 Bus Cycles for Access Space of the R8C/1B (19) Group
added, Table 9.3 Access Unit and Bus Operation;
"SFR" → "SFR, Data flash",
"ROM/RAM" → "ROM (Program ROM), RAM" revised
52
Table 10.1 Specification of Clock Generation Circuit;
Note 2: deleted
56
Figure 10.4 OCD Register;
Note 3: partly deleted
60
10.2.1 Low-speed On-Chip Oscillator Clock;
"The application products ... to accommodate the frequency range." →
"The application products ... for the frequency change." revised
10.2.2 High-Speed On-Chip Oscillator Clock;
"The high-speed on-chip oscillator frequency ... for details." added
62
Table 10.2 Setting and Mode of Clock Associated Bit;
Medium-speed Mode/devide-by-16: "00b"" → "11b"
High-speed,... Mode/devide-by-2: "00b"" → "01b"
CM13 added
67
10.5.1 How to Use Oscillation Stop Detection Function;
"This function cannot ... is 2 MHz or below." →
"This function cannot be ... is below 2 MHz." revised
68
Figure 10.9 Procedure of Switching Clock Source From Low-Speed On-
Chip Oscillator to Main Clock revised
69
10.6.2 Oscillation Stop Detection Function;
"Since the oscillation ...frequency is 2MHz or below, ..." →
"Since the oscillation ...frequency is below 2MHz, ..." revised
10.6.4 High-Speed On-Ship Oscillator Clock added.
70
Figure 11.1 PRCR Register;
After Reset: "XXXXX000b"" → "00h" revised
84
Figure 12.11 INTEN and INT0F Registers;
After Reset: "XXXXX000b"" → "00h" revised
Description
Summary
"Prescaler Z" → "Prescaler Z Register"
"Timer Z Secondary" → "Timer Z Secondary Register"
"Timer Z Primary" → "Timer Z Primary Register"
"Prescaler X" → "Prescaler X Register"
"Timer X" → "Timer X Register"
C - 4
Advertisement
Table of Contents
