Table of Contents
Advertisement
R8C/18 Group, R8C/19 Group
Full status check
FMR06 = 1
and
FMR07 = 1?
No
FMR07 = 0?
No
FMR06 = 0?
No
Full status check completed
NOTE:
1. To rewrite to the address where the program error occurs, check if the full
status check is complete normally and write to the address after the block
erase command is executed.
Figure 17.15
Full Status Check and Handling Procedure for Individual Errors
Rev.1.30
Apr 14, 2006
REJ09B0222-0130
Yes
Command sequence error
Yes
Erase error
Yes
Program error
Page 194 of 233
Command sequence error
Execute the clear status register command
(set these status flags to 0)
Check if command is properly input
Re-execute the command
Erase error
Execute the clear status register command
(set these status flags to 0)
Erase command
re-execution times ≤ 3 times?
Yes
Re-execute block erase command
Program error
Execute the clear status register
command
(set these status flags to 0)
Specify the other address besides the
write address where the error occurs for
(1)
the program address
Re-execute program command
17. Flash Memory Version
No
Block targeting for erasure
cannot be used
Advertisement
Table of Contents
