Marking Unit; Exchange Of Marking Unit - ABB FlexMT Product Manual

8.10 Marking unit

8.10.1 Exchange of marking unit

The marking unit can can be exchanged by the following procedure:
3HAC051768-001 Revision: -
• Disconnect the electrical contact by turning it anticlockwise
• Unscrew the four M6 screws holding the marking unit
• Replace with a new marking unit in reverse order.
CAUTION
If there are any changes in position/design between the new and old unit the
robot positions need to be updated.
CAUTION
Run system at slow speed for the first cycles to ensure the air cleaning box is
in correct position.
© Copyright 2014-2014 ABB. All rights reserved.
8 Repair
8.10.1 Exchange of marking unit
189