General - ABB FlexMT Product Manual

1.2 General

This sections covers safety precautions regarding the standard equipment as well
as options that are not included in all installations. If the installation contains further
parts, safety instruction may also be found in other documentation.
General safety precautions for all procedures where there is a risk of personal
injury or damage to property can be found in this chapter. Additional instructions
can also be found close to the instructions for each procedure.
Equipment that is part of a fully- or semi-automatic system must always be treated
with care regarding safety during the installation phase, during operation as well
as during maintenance and repair.
Installation/commissioning personnel must be trained and thoroughly understand
the principles of the FlexMT, to prevent risks to the operator and service personnel.
Users of the FlexMT system must ensure that the safety laws and regulations that
apply to their respective country are followed and that all safety devices that are
required to guarantee the safety of those who work with the robot are installed
correctly.
Only personnel with required training is authorized to use the system.
Trainee operators may only use the system under the supervision of a qualified,
experienced operator as follows:
Activity
Installation/commis-
sioning
Operation
Fault tracing
Correction of mechan-
ical fault
Correction of electric-
al fault
Service
Maintenance
x = Authorized to perform the activity
Received training must be documented in writing.
Always check that the installation and maintenance instructions are supplied.
3HAC051768-001 Revision: -
Trained operator
×
DANGER
Be aware of inherent risks of robot systems ! Safety information for the robot
system is supplied in the robots product manual. Ensure that you have read
these instructions and follow them.
© Copyright 2014-2014 ABB. All rights reserved.
Trained service and Qualified electrician
maintenance techni-
cians
× x
×
× ×
×
×
× ×
× ×
1 Safety
1.2 General
15