Motion And Zone Overview - ABB FlexMT Product Manual

5 Robot program

5.10 Motion and zone overview

5.10 Motion and zone overview
The principal motion in the FlexMT is controlled by the MoveTo-routine, which
moves the robot from known zone positions to a target zone position. From these
zone positions (viaPositions), movement within certain areas of the FlexMT can
be initiated.
A schematic view of the principle motion within the FlexMT is shown and main
positions is shown in the next figure.
The pre-configured setup of FlexMT zones is shown in the figure thereafter.
Schematic motion overview
Continues on next page
110
© Copyright 2014-2014 ABB. All rights reserved.
3HAC051768-001 Revision: -