Conveyor Belt Adjustment - ABB FlexMT Product Manual

7.3.6 Conveyor belt adjustment

What: Adjust the conveyor belt
When: When it starts to move sideways or slackens.
How:
The belt is adjusted when test operation is performed at the manufacturer, however,
it may need to be readjusted after transportation or after repair.
3HAC051768-001 Revision: -
• Check that the rollers are installed at exactly 90˚ in relation to the frame.
• Tighten the adjustment screw that is located on the side that the belt oscillates
on (maximum ¼ turn at a time) until the belt no longer moves sideways. Wait
until the belt has gone around 10 times before the next adjustment.
Note
After each adjustment the belt must be run for approximately 30 minutes at the
same time while being monitored, as it takes some time for the belt to react to
the new settings.
© Copyright 2014-2014 ABB. All rights reserved.
7 Maintenance
7.3.6 Conveyor belt adjustment
145