ABB FlexMT Product Manual page 31

2 Installation
2.2.3 Unpacking and positioning
Continued
Pay attention on inclination in order to avoid damages to front plates.
Place the FlexMT at a suitable position relative to the machine tool. Take especially
the corridor between the FlexMT and the machine tool into account.
Remove all the absorb bags from the electrical cabinet and the rest of the machine.
Prior to transportation untreated surfaces may have been rust proofed with a layer
of oil or grease which was applied before packing. Wipe off any excess oil/grease
before installation using a lint free cloth.
Example of absorbtion bags - in the control cabinet - that must be removed.
3HAC051768-001 Revision: - 31
© Copyright 2014-2014 ABB. All rights reserved.