Operation Abb Acs355; Key Functions - ABB FlexMT Product Manual

13.2.2 Operation ABB ACS355

13.2.2.1 Key functions

ABB Inverter display
1. LCD display – Divided into five areas:
2. RESET/EXIT – Exits to the next higher menu level without saving changed values.
Resets faults in the Output and Fault modes.
3. MENU/ENTER – Enters deeper into menu level. In the Parameter mode, saves
the displayed value as the new setting.
3HAC051768-001 Revision: -
• a. Upper left – Control location:
- LOC: drive control is local, that is, from the control panel
- REM: drive control is remote, such as the drive I/O or fieldbus.
• b. Upper right – Unit of the displayed value.
• c. Center – Variable; in general, shows parameter and signal values, menus
or lists. Shows also fault and alarm codes.
• d. Lower left and center – Panel operation state:
- OUTPUT: Output mode
- PAR: Parameter mode
- MENU: Main menu.
- FAULT: Fault mode.
• e. Lower right – Indicators:
- FWD (forward) / REV (reverse): direction of the motor rotation
- Flashing slowly: stopped
- Flashing rapidly: running, not at setpoint
- Steady: running, at setpoint
- SET: Displayed value can be modified (in the Parameter and Reference
modes).
© Copyright 2014-2014 ABB. All rights reserved.
13 Appendix A: Configuration
13.2.2.1 Key functions
Continues on next page
211