Safety During Setup, Maintenance And Repair - ABB FlexMT Product Manual

1.4 Safety during setup, maintenance and repair

Work on mechanical systems must only be carried out by qualified personal or by
an instructed person under guidance and supervision of a qualified person
according to the applicable technical regulations
Work on electrical systems or operating material must only be carried out by a
qualified electrician or by an instructed person under guidance and supervision of
a qualified electrician according to the applicable electrical technical regulations.
The equipment can start without prior warning thus causing a crushing risk. Installed
protection that belongs to the equipment must always be installed during
semi-automatic and fully automatic operation.
Mechanical, pneumatic or electrical energy may be stored in the machine, which
may cause a risk when carrying out work inside the FlexMT.
The function of safety devices must be checked after all work that might have an
impact on the safety arrangements.
3HAC051768-001 Revision: -
DANGER
The following must be ensured before commencing work on the FlexMT:
• Emergency stop must be activated (machine stationary)
• Machine voltage must be disconnected
• Action must be taken so that machine voltage cannot be connected when
work is carried out.
• The air supply must be disconnected.
• Action must be taken so that air supply cannot be connected when work is
carried out.
• The key for resetting the safety stop must be carried when working within
the FlexMT housing.
© Copyright 2014-2014 ABB. All rights reserved.
1.4 Safety during setup, maintenance and repair
1 Safety
17