General - ABB FlexMT Product Manual

7 Maintenance

7.2 General

7.2 General
This section covers maintenance procedures for the FlexMT.
Most maintenance of the FlexMT is obvious to perform, even if not listed in this
section.
This sections covers both maintenance of equipment and options that are not
included in all installations. If the installation contains further parts, maintenance
instruction may also be found in other documentation.
The machine is made of components that have a minimal maintenance requirement.
However, there are some components that require scheduled maintenance.
Only perform maintenance when the machine is off.
Below is a summary of maintenance intervals and corresponding corrective actions.
Maintenance intervals
Daily
Every week
Every month
Every 3 months
Every 6 months
If necessary
In the event of changes to
the system
Various
138
Note
Maintenance procedures for the robot are described in the robots product manual.
© Copyright 2014-2014 ABB. All rights reserved.
Corrective action
Conveyor belt cleaning
Conveyor belt check
FlexMT overall cleaning
Air cleaning box cleaning
Compressed air lubricator
Electrical function check
Gripper system check
Checking cables and cable racks
Checking contacts
Filter cartridge replacement
Conveyor belt adjustment
Replacing illumination
Replacing reflectors/sensors
Cleaning camera optic
Cleaning TFT screen
Backup robot
Backup Vision system
Robot according to robot manual
Air preparation condensate drain
Gripper system lubrication (10 Mio cycles)
3HAC051768-001 Revision: -