7.3.5 Belt tension
Normal tension for the conveyor belt is 0.5 %. If a PVC conveyor belt is used the
normal tension is 0.3%.
How to adjust the belt tension:
Screws holding protection cover.
3HAC051768-001 Revision: -
Note
Before setting the belt tension, the belt must not have been tensioned.
•
Unscrew the 4 screws holding the protection cover and remove it. See figure
below.
•
Check that the rollers are installed at exactly 90˚ in relation to the frame.
•
Make sure that the belt has never been tensioned before and is now installed
without tension.
•
Measure a distance of 1000mm in the middle of the belt and make a mark at
0 and 1000mm.
•
Using both adjustment screws (see figure 15), tension the belt until the
distance between the marks is 1005mm.
•
If a PVC belt is used the distance between the marks should be 1003mm
after tensioning the upper conveyor belt and 1004mm after tensioning the
lower conveyor belt.
•
Clean off the marks.
•
Mount the protection cover.
© Copyright 2014-2014 ABB. All rights reserved.
7 Maintenance
7.3.5 Belt tension
Continues on next page
143