Exchange Of Flexblow Hoses - ABB FlexMT Product Manual

8.8.1 Exchange of flexblow hoses

If a flexblow hose holding a blowing nozzle gets unstable it is replaced by the
following procedures:
Components of the air cleaning box and deburring tools
A: Flexblow hoses, B: Valves controlling air cleaning, C: Signal splitter box, D:
Deburring tool 1, E: Deburring tool 2, F: Valves controlling deburring tools, G:
Protective cover.
3HAC051768-001 Revision: -
• Use a wrench to hold the pneumatic connection. Turn the flexblow hose
counterclockwise until it is loose.
• Turn the blowing nozzle counterclockwise to release it from the hose.
• Replace the flexblow hose and assemble in reverse order.
CAUTION
If there are any changes in position/design between the new and old unit the
robots position need to be updated.
© Copyright 2014-2014 ABB. All rights reserved.
8.8.1 Exchange of flexblow hoses
8 Repair
183