8 Repair
8.2.1 Exchange of conveyor belt
8.2.1 Exchange of conveyor belt
Exchange a conveyor belt by the following procedure
Protective caps and release points idler drum in middle of conveyor
Continues on next page
166
•
Run the belt to a suitable exchange position. The belt splice should be close
to the end of the conveyor.
•
Remove the relevant protection cover at the end of the belt (see illustrations
below).
•
Reduce belt tension by releasing the tensioning screws (see illustrations
below).
•
Remove the idler drum below the middle of the conveyor (see illustrations
below).
© Copyright 2014-2014 ABB. All rights reserved.
3HAC051768-001 Revision: -