Configuration Changes - ABB FlexMT Product Manual

3 Commissioning

3.8.2 Configuration changes

3.8.2 Configuration changes
The controller unit is pre-configured for use with the FlexMT. Configuration changes
can be done by using the SIC controller configuration software (delivered on the
SmartCamera storage, to be installed on a separate PC, communication with
standard USB cable).
Typical changes might be modifications of the marking setup files. FlexMT is using
three different marking files for different sizes: SMALL, MEDIUM, LARGE.
For in-depth information refer to the section on pre-configuration data, especially
if you intend to modify the marking units configuration.
76
© Copyright 2014-2014 ABB. All rights reserved.
3HAC051768-001 Revision: -