Configure The Connect Sensor+ Serial Port In Skycloud - Digi SkyCloud Z4500 Series User Manual

Configure the Connect Sensor+ serial port in
SkyCloud
You can configure the Connect Sensor+ serial port in SkyCloud.
1. Log into the Connect Sensor+ web UI on SkyCloud.
2. From the Interfaces section, click Serial. The Serial Configuration page displays.
3. In the Serial Port 1 fields, configure the serial port. Refer to the table below for field
descriptions.
4. Click Update to save the configuration.
Field Description
Framing Select the framing mode you want to use for Modbus. Options are:
mode
n
n
Note
Baud Select the baud rate needed to connect to SkyCloud.
The default is 19200.
Data bits Select the number of data bits needed to connect to SkyCloud.
The default is 8 Bits.
Stop bits Select the number of stop bits needed to connect to SkyCloud.
The default is 1 Bit.
Parity Select the type of parity needed to connect to SkyCloud.
The default is None.
Power Enables or disables the power output source. Options are:
output
n
n
Output Specifies the voltage level output for the power source.
The default is 3.3 Volts.
voltage
Welcome to Digi SkyCloud
ASCII
RTU. This is the default.
This option is only used if you are using Modbus.
Enabled
Disabled: This is the default.
57