Display System Information; Activate Find Me Led; Reboot The Digi Device; Enable/Disable Access To Network Services - Digi Connect SP User Manual

Display system information

System information displays the model, MAC address, firmware version, boot version, and POST version of the Digi
device. It also displays memory available: total, used, and free, and tracks CPU percent utilization and the uptime.
From the web interface menu, select Administration > System Information. Select General, GPIO, Serial, Network,
or Diagnostics for the appropriate information. For descriptions of the information displayed on these screens, see
System information

Activate Find Me LED

For Digi Connect ES products, use the Find Me LED to aid in finding a specific Digi device server among a group of
devices. The locator LED is shown on page 113.
•
Activate: Clicking this button causes the Find Me locator LED to blink.
•
Stop: Clicking this button causes the Find Me locator LED to stop blinking.

Reboot the Digi device

Changes to some device settings require saving the changes and rebooting the Digi device. To reboot a Digi device:
1. From the web interface menu, select Administration > Reboot.
2. On the Reboot page, click the Reboot button. Wait approximately 1 minute for the reboot to complete.

Enable/disable access to network services

As needed, enable and disable access to various network services, such as ADDP, RealPort, SNMP, and telnet. For
example, for performance and security reasons, it may be desirable to disable access to all network services not
necessary for running or interfacing with the Digi device. In the web interface, enabling and disabling network
services is done on the Network Services settings page for a Digi device. See

Restore device configuration to factory defaults

There are two ways to restore the device configuration to the factory default settings:
•
Reset the configuration from a web browser, which clears all current device configuration settings except the IP
address settings and administrator password. This is the best way to reset the configuration as it allows for
backing up the settings, providing a means for restoring the settings after any configuration issues are resolved.
See Using the Administration > Factory Defaults page on the web interface
•
Reset the configuration using the reset button on the Digi device. Use this method if the device cannot be
accessed from a web browser. The location of the reset button may vary. See
Settings cleared and retained during factory reset
Restoring the Digi device to its factory default settings clears all current settings except the IP address settings and
the administrator password. Any files such as custom-interface files and applet files that were loaded through the
web interface's File Management page are retained. See
and deleting files.
Restore the configuration from a web browser
1. From the main menu, click Administration > Factory Default Settings.
Digi Connect Family and ConnectPort TS Family User Guide
on page 79.
Network services settings
on page 91 for more information.
Using the Reset button
File management on page 89 for information on loading
on page 38.
on page 91.
93