Information; Cli Configuration - Tripp Lite NGI-M08POE8-L2 Owner's Manual

Click Refresh to begin configuring this screen afresh.
Refresh
Port Status
Port
This field displays the port number.
State
This field displays whether the port is enabled or disabled.
This field displays the speed either 10M, 100Mor 1000Mand the duplex
Speed/Duplex
mode Full or Half.
Flow Control
This field displays whether the port's flow control is On or Off.
This field displays the link status of the port. If the port is up, it displays the
Link Status
port's speed, duplex and flow control setting. Otherwise, it displays Link
Down if the port is disabled or not connected to any device.

5.4.2. Information

5.4.2.1. CLI Configuration

Node Command
enable show interface IFNAME
enable configure terminal
configure interface IFNAME
interface show
interface description STRING
interface no description
interface alias STRING
interface no alias
configure interface range
gigabitethernet1/0/PORTLISTS
if-range description STRINGs
if-range no description
if-range alias STRING
if-range no alias
Description
This command displays the current port
configurations.
This command changes the node to
configure node.
This command enters the interface
configure node.
This command displays the current port
configurations.
This command configures a description
for the specific port. The length of
description is up to 240 characters.
This command configures the default
port description.
This command configures an alias for
the specific port. The length of alias is
up to 64 characters.
This command reset the alias to default.
This command enters the if-range
configure node.
This command configures a description
for the specific ports.
This command configures the default
port description for the specific ports.
This command configures an alias for
the specific ports. The length of alias is
up to 64 characters.
This command reset the alias to default.
58