Ps/2 Server Interface Unit; Usb Server Interface Unit; Connecting The Power Supply - Tripp Lite B072-008-1A Owner's Manual

5. Installation

5.5.1 PS/2 Server Interface Unit

Connecting a NetCommander PS/2 Server Interface Unit (B078-101-PS2)
1. Shut down the computer being connected to the B078-101-PS2 (SIU)
2. Connect the B078-101-PS2 VGA connector to the computers VGA port
3. Connect the B078-101-PS2 PS/2 Keyboard connector to the computers PS/2 Keyboard port
4. Connect the B078-101-PS2 PS/2 Mouse connector to the computers PS/2 Mouse port
5. Connect one end of the Cat5e/6 patch cable to the RJ45 port on the B078-101-PS2*
6. Connect the other end of the Cat5e/6 patch cable to the desired RJ45 CPU port*
7. Repeat these steps for each additional PS/2 computer/server you are connecting to the KVM
* Cat5e/6 cable should be no longer than 100 ft.

5.5.2 USB Server Interface Unit

Connecting a NetCommander USB Server Interface Unit (Model # B078-101-USB-1)
1. Connect the B078-101-USB-1 VGA connector to the computers VGA port
2. Connect the B078-101-USB-1 USB connector to the computers USB port
3. Connect one end of the Cat5e/6 patch cable to the RJ45 port on the B078-101-USB-1*
4. Connect the other end of the Cat5e/6 patch cable to the desired RJ45 CPU port*
5. Repeat these steps for each additional USB computer/server you are connecting to the KVM
* Cat5e/6 cable should be no longer than 100 ft.

5.6 Connecting the Power Supply

1. Plug in the KVM. Use only the power cord supplied with the unit.
2. Switch ON the computers.
15-08-291-933350.indd 6
(continued)
Up to 100 ft.
SIU = Server Interface Unit
Figure 5.5.1 NetCommander PS/2 Server Interface Unit
Up to 100 ft.
SIU = Server Interface Unit
Figure 5.4.2 NetCommander USB Server Interface Unit
6
To computer's
keyboard port
To computer's
mouse port
SIU
To computer's
VGA port
To VGA port To USB port
8/31/2015 9:59:10 AM