Serial tally settings (Serial Tally)
Make the serial tally settings, including tally type and source address for each
serial tally port.
Simple Connection to MKS-8080/8082 AUX Bus Remote
Panel (Option)
To connect the MKS-8080/8082 AUX Bus Remote Panel to a CCP-8000
Center Control Panel using an S-Bus data link requires a BKPF-R70A Routing
Switcher Controller Board or similar primary station and various settings for
connection.
However, using a simple connection, the need for an S-Bus data link primary
station is avoided, and direct connection to the MKS-8080/8082 is possible.
A simple connection is possible if the following conditions are met:
• There are no devices other than the CCP-8000 and MKS-8080/8082
connected on the S-Bus data link.
• There are no more than 16 MKS-8080/8082 units connected on the S-Bus
data link.
For details of the connection procedure, see "Procedure for Simple
Connection" in Chapter 16 (Volume 2).
185
Setup