Toyota 02-8FGF15 Operator's Manual page 78

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 3
01_A5028-0EA04_En.fm Page 85 Monday, June 27, 2011 10:08 AM
3. Switch on the ignition key without starting
the engine, the red diode lights and the green
diode (V2) or yellow diode (V3) blinks
according to the time setting (see table opposite)
4. Turn the time setting with an hexagon socket
wrench of 2mm (V2 release) or a little cross
scrwedriver (V3 release) as shown in table
opposite.
.
Note:
To verify the value of the time setting, you need
to switch off and then switch on the ignition.
5. Close carefully the cover of the box so that the
card won't slide .
Starting up the truck again
When the truck has been turned off by the cut-off device, turn the ignition key on OFF.
Now you can start your truck again.
IMPORTANT RECOMMENDATION
ABOUT FORKS LENGTH
IF YOUR TRUCK IS EQUIPPED WITH A FORK POSITIONER
WITH SIDE SHIFTER SERIES K (35K,55K,70K):
SERIAL
55K-IFS-A115
NUMBER
CATALOG
NUMBER
ADDITIONAL
EQUIPMENT
ADDITIONAL
EQUIPMENT
ADDITIONAL
EQUIPMENT
The maximum authorised
forks length is 1500mm.
POS.
Duration
Flashes
1
30 sec.
1 time + 1 time
.
2
1 mn.
1 time + 2 times
3
2 mn.
1 time + 3 times
4
3 mn.
1 time + 4 times
5
4 mn.
1 time + 5 times
6
5 mn.
1 time + 6 times
ATTACHMENT CAPACITY
LIFT TRUCK ATTACHMENT
POUNDS
INCH LOAD
AT
CENTER
CAPACITY OF TRUCK AND ATTACHMENT COMBINATION
MAY BE LESS THAN ATTACHMENT CAPACITY SHOWN
WEIGHT
ABOVE. CONSULT TRUCK NAMEPLATE.
LBS
RECOMMENDED SYSTEM PRESSURE – 2000 PSI
MAXIMUM SYSTEM PRESSURE – 2300 PSI
T
FOR TECHN CAL
FOR PARTS AND SERV CE
ASS STANCE
CONTACT
MANUALS CONTACT
80
27 2233
800 227 2233
PORTLAND OREGON USA
SPR NGF ELD OH O USA
L ≤ 1500
SPECIALS MODELS
TOYOTA WIRELESS INFORMATION SYSTEM (T.W.I.S.)
The DHU-unit described in this manual is approved for use in GSM 900/1800 networks.
The following safety precautions must always be followed during installation, operation,
service and repair work.
If these safety precautions are not followed, it can result in a breach of the product's safety
standards regarding design, manufacturing and intended area of use.
The manufacturer is not responsible for the consequences if these safety pre-cautions are
'
disregarded.
The DHU-unit emits radio waves when switched on.
Remember that interference can occur if it is used near TVs, radios, computers or equipment
without adequate protection.
DANGER!
Risk of interference in medical equipment.
T.W.I.S. emits radio waves in the same way as cell phones and can therefore cause
interference in medical equipment. Interference may result in patient safety being
jeopardized.
If T.W.I.S is to be used near medical equipment, the same rules as for cell phones
must be followed within the area concerned.
DANGER!
Risk of fire or explosion.
T.W.I.S can cause sparks that can ignite inflammable chemicals.Do not use T.W.I.S.
in filling stations or close to fuel or other inflammable chemicals.
DANGER!
Risk of unintentional detonation of explosives.
Radio waves from T.W.I.S. can cause the unintentional detonation of explosives
by primed detonators or similar being aaffected.
The same rules that apply for radio transmitters must be followed in the proximity of
blasting areas, which usually means that T.W.I.S. must not be used there.
v
en-77
en

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents