Toyota 02-8FGF15 Operator's Manual page 69

01_A5028-0EA04_En.fm 68 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
en-68
2. Parking for a long time.
(1) Turn the LPG tank outflow valve clock-
wise to shut the fuel supply.
(2) Let the engine stop naturally so that any
LPG fuel in the piping leaves the system.
Turn the fuel switch and the ignition
switch to the "" (OFF) position and
remove the key.
Changing the LPG tank
Caution Caution
Under no circumstances what so ever may
the LPG tank replacement be performed
near a lighted cigarette, lighted match, gas
stove burner, electric heater, motor or any
other electric appliance that emits sparks,
flame or any type of fire (referred to collec-
tively as "fire" below).
Warning
To avoid serious injury from fire or explo-
sion, you must follow these rules:
• Switch ignition and lights off.
• Change tanks only in well ventilated,
approved areas.
• No fire or flames allowed.
• Check all connections for damage or
missing parts.
• Check for leaks.
• Do not restart until all smell of gas is
gone.
• If vehicle will not restart, get a mechanic
to inspect it.
• Filling tanks requires special proce-
dures.
Make sure someone explains them all to
you.
(1)
(1) Engine hood lock release lever
Engine hood
Opening
1. Pull the set pin at the bottom left portion
of the tank bracket.
2. Bring the clamped tank with the bracket
down toward the rear side of the vehicle.
3. Pulling up on the engine hood lock
release lever will release the engine hood
lock, and the engine hood will pop up
slightly.
4. Lift the engine hood.
5. Open the engine hood all the way, then
shake the hood slightly to check that the
hood damper has been securely fastened
before letting go.