Toyota 02-8FGF15 Operator's Manual page 39

01_A5028-0EA04_En.fm 38 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
(1)
(1) Push
(1)
(1) Fork lever
(1)
(1) Draw bar
en-38
Closing
1. Lift up the engine hood, press the hood
damper lock to release the lock.
2. Close the hood quietly, and press down
on the hood until you hear a clicking
sound.
3. Return the seat and arm rests to their nor-
mal position.
Caution Caution
Working on the engine without firm locking
of the hood may be hazardous.
Forks
Lift each fork stopper and turn to release so
that forks can be shifted left and right.
Adjust the forks in the position most appropri-
ate for the load.
When adjusting the forks, make sure that the
center of gravity of the load corresponds to the
center of the vehicle. After adjustment, turn the
stoppers to lock the fork in place.
Warning
Make the forks are locked before carrying a
load.
Draw bar
The draw bar is located at the back of the coun-
terweight, and is used to pull the vehicle
should its tires drop into a gutter or become
stuck in mud.
It can also be used for loading the forklift onto
a vehicle or another vehicle.
Caution Caution
The draw bar should not be used for towing
the forklift or for towing another vehicle
using the forklift.
Vehicle hoisting method
When hoisting the vehicle, use the lifting holes
near the top of the mast for the front side and
the overhead guard for the rear position as
shown in the illustration.
Caution Caution
• Use wire cable which is sufficiently
strong.
• Never use the holes on the upper side of
the counterweight to hoist the vehicle.