Toyota 02-8FGF15 Operator's Manual page 27

01_A5028-0EA04_En.fm 26 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
(1)
(1) Automatic forks leveling switch
en-26
Automatic fork leveling switch
(Works same as the tilt lever knob
switch.)
While pressing the switch when the forks are
tilted forward from a backward-tilted position,
or backward from a forward-tilted position, the
forks will automatically stop at a horizontal
position. Releasing the switch will allow for
normal tilt lever operation.
Forks forward-tilt automatic leveling control
When the forks are in a backward-tilted posi-
tion, operating the lever forward while
depressing the automatic fork leveling switch
will automatically stop the forks at a horizontal
position. This function is convenient when
handling loads or attaching/detaching forks.
While depressing the automatic fork leveling
switch, operating the forks forward from a
backward-tilted position:
Not loaded Loaded
High lift Forks stopped at their horizontal No forward tilt
position
(with mast vertically positioned)
Low lift Forks stopped at their horizontal position
(with mast vertically positioned)
Forks backward-tilt automatic leveling control
When the forks are in a forward-tilted position,
operating the lever backward while depressing
the automatic fork leveling switch will auto-
matically stop the forks at a horizontal posi-
tion. This function is convenient when using
clamp-type attachments while the mast is tilted
forward from the vertical position.
While pressing the automatic forks leveling
switch, operating the forks backward from a
forward-tilted position:
Not loaded Loaded
High lift
Forks stopped at their horizontal position
(with mast vertically positioned)
Low lift
(1)
(1) Load meter switch
(1)
(1) Attachment lever
Active mast rear tilt speed control
When the mast is raised to a high position,
backward-tilt speed will automatically slow
down.
Load meter switch (Option)
For vehicles equipped with Multifunction dis-
play DX (Option), pressing the load meter
switch will display the weight of the load.
Note:
• Operate this function when you are not per-
forming loading operations.
• When weighing the load, always remember
to position the load at a height of about
500mm above the ground and make the
mast perpendicular.
Attachment lever
Operates the attachment.
Attachment speed can be adjusted by the
extent of pressing the accelerator pedal and
operating the lever.
Note:
• After the OPS System has been activated,
return the accelerator pedal and all of the
levers to their neutral positions and return
to the seat position before recommencing
operations.
• Always operate the attachment lever from a
properly seated position.