Self Servicing - Toyota 02-8FGF15 Operator's Manual

01_A5028-0EA04_En.fm 53 ページ ２０１２年１２月６日 木曜日 午後１２時４２分

SELF SERVICING

(1) (2) (1) (2)
1 1
5 8
3 6
3 4
5 4
7 6
2
2
(1) Hub nuts
(2) Rim nuts
(Never loosen without removing the air)
Changing tires
Caution Caution
• Use proper safety precautions when
jacking the vehicle.
Never get under the forks or frame.
• In the case of a wheel with a divided rim,
do not loosen the rim bolts and nuts
when loosening the hub nuts. When loos-
ening the rim nuts or removing the rim
bolts, be sure to completely remove the
air before loosening.
• Refer to service data for hub nut tighten-
ing torque and tire air pressure.
• Tire air pressure is very high, so pay
attention to rim deformation, cracks, etc.
Never exceed proper air pressure.
• Do not replace any tire without turning
on the ignition switch before jacking up
the vehicle. Upon completion of the tire
replacement, return the ignition switch
to the OFF position.
Front wheels
1. Unload the vehicle and place it on level
ground.
2. Set the parking brake and chock the
wheels. Locate the jack-up point on the
bottom surface of the frame in the rear of
a front tire. Securely insert the jack there.
Confirm that the jack is properly posi-
tioned.
3. Jack up to just prior to the wheels coming
up off the ground and loosen the hub
nuts.
4. Jack up until the wheels come off the
ground. Completely remove the air pres-
sure from the tire then remove the hub
nuts and remove the wheel.
5. To reinstall the wheel after changing a
tire, perform the steps for removing in
reverse order. The hub nuts should be
tightened evenly and in the sequence
shown in the figure.
6. After replacing the wheel, check and
adjust the tire air pressure.
(1) (2)
1
3 6
5
4
2
(1) Hub nuts
(2) Rim nuts
(Never loosen without removing the air)
(1)
(2)
(1) Garage jack
(unavailable in 1-ton models)
(2) Pulsometric type jack
Rear wheels
1. Place the vehicle on level ground.
2. Set the parking brake and chock the
wheels then insert the jack under the
weight.
Caution Caution
Never loosen the divided rim nuts. Should
any of the nuts be found loose or otherwise
abnormal, deflate the tires and then loosen
the hub nuts to remove the tires.
Jack setting position
Apply the jack to the jack point under the
counter-weight.
Caution Caution
Be sure to use a jack whose capacity is 5.0
ton or more.
3. Jack up to just prior to the wheels coming
up off the ground and loosen the hub
nuts.
4. Jack up until the wheels come off the
ground. Completely remove the air pres-
sure from the tire then remove the hub
nuts and remove the wheel.
5. To reinstall the wheel after changing a
tire, perform the steps for removing in
reverse order.
The hub nuts should be tightened evenly
and in the same sequence as for the front
wheels.
6. After replacing the wheel, check and
adjust the tire air pressure.
en-53
en