Toyota 02-8FGF15 Operator's Manual page 28

01_A5028-0EA04_En.fm 27 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
(1)
(1) Attachment lever switch
(1)
(2)
(1) Forward
(2) Backward
Attachment lever switch
(Only for 5 ways series)
This switch allows attachment lever operations
to be switched between the 3rd and 4th ways.
It is for 3rd operation when the changing-over
switch is not switched. And it switches to 5th
operation while pushing it.
Caution Caution
Operate the attachment lever switch when
attachment operations are stopped.
Joy stick (Option)
Control lever
Lever for shifting between forward and
reverse.
Forward .................................... Push forward
Reverse..................................... Pull backward
The speed of forward and backward traveling
can be adjusted by the extent of pressing the
accelerator pedal.
Note:
• Stop the vehicle before shifting between
forward and backward traveling.
• After the OPS System has been activated,
return the accelerator pedal and control
lever to their neutral positions and return to
the seat before recommencing operations.
• Always operate the control lever from a
properly seated position.
• Depending on the vehicle specifications,
the position of the control lever may vary.
(1)
(3)
(2) (4)
(1) Raising
(2) Lowering
(3) Forward-tilt
(4) Backward-tilt
(1)
(1) Lift lock release bolt
Lift tilt lever
Operation to the left and right controls lift, and
forward and backward operation controls tilt.
Raising ...............Operate the lever to the right
Lowering .............. Operate the lever to the left
Forward-tilt ............Operate the lever forward
Backward-tilt.......Operate the lever backward
Raising speed and forward and backward-tilt
speed can be adjusted by the extent of pressing
down on the accelerator pedal and operating
the lever.
Lowering speed can be adjusted by operating
the lever.
Note:
• Using the idling lifting speed increase func-
tion (Option), when the lift tilt lever is
raised, the engine's speed is automatically
increased without having to press the accel-
erator pedal, allowing the forks to be raised
at a constant speed.
• After the OPS System has been activated,
return the accelerator pedal and all of the
levers to their neutral positions and return
to the seat before recommencing opera-
tions.
• If you return to seated position while low-
ering the lift lever, the lift will not descend
due to the return to neutral warning func-
tion.
• Always operate the load handling lever
from a properly seated position.
• If you use the idling lifting speed increase
function (Option), pulling the lift lever will
automatically increase the engine speed
and raise the forks at a constant speed with-
out having to step on the accelerator pedal.
• When the ignition switch is turned to OFF,
the forks will not descend even if the lift
lever is lowered. (Key-lift interlock)
• When the forks will not lower due to sys-
tem malfunction or other reasons, they can
be lowered by opening the lift lock release
bolt.
• If you lower the forks by opening the lift
lock release bolt, close and lock the bolt.
en-27
en