Toyota 02-8FGF15 Operator's Manual page 19

01_A5028-0EA04_En.fm 18 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
(1)
(1) Low speed setting switch
en-18
Low speed setting indicator
(Only for DX models with Auto
speed control)
When low speed settings have been set, the
turtle mark is displayed.
Each time the low speed setting switch is
pressed, the turtle indicator will light up. When
the indicator is lighted, the low speed setting
control is active.
Note:
Always operate the switch panel with your fin-
ger tips.
Auto speed control indicator
(Only for DX models with Auto
speed control)
When the load height and weight sensors to
prevent sudden acceleration or the speed limits
after load lifting height and weight sensing are
in operation, the auto speed control indicator is
displayed to inform the operator.
Function on/off indicator
(Only for DX models with Auto
speed control)
Even when the speed limits after load lifting
height and weight sensing is deactivated, the
operator is notified via display indication that
the preventing sudden starts function is active.
Parking brake on warning
When the parking brake is engaged while the
lift vehicle is traveling, the warning indicator
will blink and a warning will sound to notify
the operator.
Caution Caution
• If the vehicle is operated without disen-
gaging the parking brake, the brake will
lose effectiveness. Contact your Toyota
dealer to request an inspection.
• If the indicator lamp does not turn off
even when the parking brake is disen-
gaged, stop operations and contact your
Toyota dealer to request inspection.
Parking brake off warning
When the ignition switch is turned to OFF or
the operator leaves the seat while the parking
brake is disengaged, a warning sound will
warn the operator to apply the parking brake.
The warning will also be sounded if the opera-
tor returns to the normal seated position and
turns the ignition switch to ON while the park-
ing brake is disengaged.
Note:
• When the parking brake is applied, the
warning sound will stop.
• When leaving the driver's seat, always shift
to NEUTRAL, set the parking brake, lower
the forks, and tilt forward so the tips will
not trip pedestrians, and turn off the igni-
tion switch.
Torque converter oil temperature
overheating warning
When the torque converter oil temperature
reaches level 9 on the indicator (120ºC or
over), the indicator will blink to notify the
operator. When the indicator reaches level 10
(140ºC or over), the entire indicator will blink
to notify the operator.
Note:
When the warning lamp blinks, park the vehi-
cle in a safe location, engage the parking
brake, open the engine hood with the motor
idling, to assist in the cooling of the torque
converter oil.