Toyota 02-8FGF15 Operator's Manual page 18

01_A5028-0EA04_En.fm 17 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
Load meter
(Only with DX models)
Pressing the lift lever knob switch or the load
meter switch (mini lever models) will allow
the operator to confirm the weight of the load
being handled.
Note:
In the case of joy stick models (Option), the
load meter switch and fork automatic leveling
control switch functions are combined.
1. Adjust the load to a height of 500mm
above ground level and set the mast verti-
cal.
2. In the standard screen, press the lift lever
knob switch or the load meter switch
(mini lever models).
Note:
• For each operation, the meter reading will
display for 3 seconds. (the display will
remain indicated while the switch is held
down).
• Pressing the lift lever knob switch or the
load meter switch (mini lever models)
while the vehicle is traveling will not dis-
play the load display screen.
• If the load is less than 100kg, the meter will
indicate 0.00t.
Caution Caution
This function should be used as reference
when conducting handling operations, and
not used in business dealings or as proof.
Load meter error display
When the load meter is operated while the load
is in an elevated position, an arrow will appear
at screen left and the measured weight indica-
tion will blink to notify the operator that the
reading is inaccurate.
To measure the load, always set the load to a
height of approximately 500mm above ground
and set the mast vertical.
Note:
If 0 is slightly deviated toward the minus side,
the display will indicate -0.00 t.
Load meter sensor error display
When the load meter sensor malfunctions, the
display will blink as indicated in the diagram at
left.
Note:
When the load meter sensor blinks to indicate
an error, contact your Toyota dealer to request
an inspection.
Maintenance indicator
When the preset maintenance time occurs, the
operator will be notified through the display
and a warning sound. Conduct necessary main-
tenance.
Note:
The maintenance time setting should be deter-
mined by the supervisor. For information on
setting the maintenance time, contact your
supervisor or Toyota dealer.
Diagnosis indicator
If an abnormality is registered within the Mul-
tifunction display, the operator is notified
through a warning sound together with diagno-
sis error content display.
Note:
• The error code display will be different
depending on the abnormal area and nature
of the abnormality. There are also occa-
sions when the error is not indicated
depending on the area of abnormality.
• When the diagnosis indicator is displayed,
contact your Toyota dealer to request an
inspection.
en-17
en