Table of Contents
Advertisement
Brake Maintenance
Adjusting the Brakes
If the brake fails to hold the machine while parked, you can
adjust the brakes using the bulkhead fitting near the brake
drum; contact your Authorized Service Distributor or refer to
the Service Manual for more information.
Note: Burnish the brakes annually; refer to
the Brakes (page
16).
Hydraulic System
Maintenance
Changing the Hydraulic Fluid
and Filter
Service Interval: After the first 50 hours
12 Burnishing
If the oil becomes contaminated, have your Toro distributor
flush the system. Contaminated oil looks milky or black when
compared to clean oil.
1. Clean the area around the filter mounting area
1. Hydraulic-oil filter
2. Fill the replacement filter with the appropriate hydraulic
3. Fill the hydraulic reservoir with hydraulic fluid; refer to
4. Start the machine and run it at idle for 3 to 5 minutes
5. Dispose of the oil and filter properly.
41
Every 800 hours
49). Place a drain pan under the filter and remove the
filter.
Figure 49
Note: If you will not be draining the oil, disconnect
and plug the hydraulic line going to the filter.
fluid, lubricate the sealing gasket, and hand turn it until
the gasket contacts the filter head. Then tighten it 3/4
turn further.
Filling the Hydraulic Tank (page
to circulate the fluid and remove any air trapped in the
system. Shut off the engine and check the fluid level.
(Figure
1
g014619
25).
Advertisement
Table of Contents
