Installing The Cutting Deck; Installing The Drive Belt - Toro ProLine 30152 Operator's Manual

Installing the Cutting Deck

1. Position the cutting deck under the carrier frame.
2. Mount the cutting deck to the carrier frame with
four (4) clevis pins and hairpin cotters (Fig. 3).
Note: All four pins must be in the same hole
locations to prevent uneven cutting.
1
2
3
4
5
6
7
10
11
Figure 3
1. 2" (51 mm) Cut Height
2. 2-1/2" (64 mm) Cut Height
3. 3" (76 mm) Cut Height
4. 3-1/2" (89 mm) Cut Height
5. 4" (102 mm) Cut Height
6. 4-1/2" (114 mm) Cut
Height
8
9
7. 5" (127 mm) Cut Height
8. Clevis Pin
9. Carrier Frame
10. Cutting Deck
11. Hairpin Cotter

Installing the Drive Belt

1. Remove the hand knobs holding the deck cover
to the top of the cutting unit and remove the
deck cover.
2. Install the drive belt around the drive pulley on
the traction unit and the upper groove of the
center spindle pulley. The belt must be between
the belt guides (Fig. 4).
3. Reinstall the deck cover onto the cutting unit,
then reinstall and tighten the hand knobs.
4
Figure 4
1. Belt Guide (2)
2. Traction Unit Drive Pulley
Assembly
2
1
3
3. Drive Belt
4. Center Spindle Pulley
5