Cutting Deck Rollers and Skids
g223660
1.
Right skid
2.
Cutting deck
3.
Left skid
4.
Flange nut (5 each)
Removing the Cutting Deck Rollers and Skids
Installing the Cutting Deck Rollers and Skids
Cutting Units: Service and Repairs
5.
Carriage screw (4 each)
6.
Washer-head screw (2 each)
7.
Locknut (2 each)
8.
Roller (2 each)
1. Remove the skids and rollers from the cutting deck
1. Install the skids to the cutting deck
the same mounting hole height position (lower or upper).
2. When you install the rollers to the deck, tighten the nut until the roller will not
rotate, then loosen the nut only enough to allow the roller to rotate freely.
Ensure to install all the cutting deck rollers in the same mounting hole height
position (lower or upper).
Figure 307
10.
11.
12.
(Figure
Page 10–20
9.
Bolt (2 each)
Roller
Roller shaft
Flange-head screw
(Figure
307).
307). Ensure to install the skids in
Groundsmaster
05138SL Rev B
®
3280-D/3320