Cutting Deck Service Latch (Groundsmaster 3500 Only); Separating Cutting Decks From Traction Unit; Mounting Cutting Decks To Traction Unit - Toro 30834 Operator's Manual

Cutting Deck Service Latch
(Groundsmaster 3500–D only)
When servicing cutting decks, use the service latch to
prevent injury.
1. Center cutting deck sidewinder with the traction unit.
2. Raise cutting decks to transport position.
3. Set parking brake and turn off machine.
4. Release latch rod (Fig. 8) from front carrier frame
retainer.
1
Figure 8
1. Service latch hook
5. Lift outside of front cutting decks and place latch over
frame pin mounted on front of operators platform
(Fig. 8).
6. Sit on operator seat and start traction unit.
7. Lower cutting decks to mow position.
8. Turn off machine and remove key.
9. Reverse procedure to unlatch cutting decks.
Separating the Cutting Decks
from the Traction Unit
1. Position machine on level surface, lower cutting decks
to floor, shut engine off, and engage parking brake.
2. Disconnect and remove hydraulic motor from deck
(Fig. 9). Cover top of spindle to prevent contamination.
1
1. Motor mounting screws
3. Remove lynch pin or retaining nut (GM4700 only)
securing deck carrier frame to lift arm pivot pin
(Fig. 10).
Figure 10
1. Lynch pin
4. Roll the cutting deck away from the traction unit.
Mounting the Cutting Decks to
the Traction Unit
1. Position machine on a level surface and shut engine off.
2. Move cutting deck into position in front of traction unit.
3. Slide deck carrier frame onto lift arm pivot pin. Secure
with lynch pin or retaining nut (GM 4700 only)
(Fig. 10).
4. Install hydraulic motor to deck (Fig. 9). Make sure
O-ring is in position and not damaged.
5. Grease spindle.
11
1
Figure 9
1
2
2. Lift arm pivot pin