Bearing Dismantling - Porsche 911 GT3 Cup 2018 Techical Manual

2.8.13 Bearing dismantling

Gearbox housing
Remove the needle bearing of the cross shaft with puller HAZET 788-37 (Figure
2.8.13.1)
Information
Clean the gearbox housing and remove any oil
Caution
Heat the gearbox housing at 130 °C (266 F) for 30 minutes
Remove the outer rings of the bearings in the housing. The outer rings of the bearing
can be dismantled without applying great force.
Outer ring of the drive shaft bearing (Figure 2.8.13.2)
Screw the pinion shaft retaining frame (4) off the gearbox housing
Take out the four-point bearing (2)
Remove the outer ring of the pinion shaft cylinder roll bearing (Figure 2.8.13.4)
Version: 4/20/2018
The pulling off motion requires the utmost care. The
gearbox housing could be damaged in the process!
Hot components
Danger of burns
Wear personal protective equipment.

Powertrain
2.8.13.1
2.8.13.2
2.8.13.3
2.8.13.4
911 GT3 Cup (991 II)
MY 2018
95