Switch Settings; Led Indications - NEC Univerge SV8100 System Hardware Manual

Issue 4.1
SW6-1
SW6-2
SW6-3
SW6-4
4 - 22
3.1.3

Switch Settings

Refer to Table 4-5 CD-CP00 Switch Settings
system reset and with system power on.
Layout on page 4-16
CD-CP00 blade.
USB Memory Status
With a system restart or a system reset while holding the SW1
switch:
When USB Memory is not
installed:
Switch
SW1 - Load
When USB Memory is
Switch
installed:
When an unauthorized USB
device is installed:
Table 4-6 CD-CP00 Switch 6 Settings
Configuration
ON
OFF
OFF
ON
3.1.4

LED Indications

The LEDs on the CPU indicate the following:
Customer information is stored in the RAM memory and, in
case of a power failure, will be restored. The lithium battery in
the system saves the RAM memory when power is lost.
shows the location of the SW1 switch on the
Table 4-5 CD-CP00 Switch Settings
Not Used
Test Mode
RS232C Select
Reset Configuration
UNIVERGE SV8100
for system restart/
Figure 4-3 CD-CP00 Blade
Operation
Cold Start occurs.
USB Memory contents loaded.
System does not start and an "Illegal
USB device is connected" alarm is
recorded.
Note
ON = Test Mode
OFF = Normal
ON = Use
OFF = Not Used
ON = Normal
OFF = ICE Mode
Installing the SV8100 Blades