50
Parameterizing
To open the parameterization user interface (DTM) of the module, double-click
on the module in the "Network View" of WAGOframe. The parameterization user
interface can also be opened by right-clicking on Offline Parameter or Online
Parameter in the context menu.
If several DTMs are open, select one via the corresponding tabs.
Depending on the DTM you have selected, different buttons are provided:
Table 22: DTM buttons
Buttons
[Read]
(Online mode only)
[Write]
(Online mode only)
[Close]
(Online and offline mode)
[Apply]
(Offline mode only)
[Help]
(Online and offline mode)
Pos : 30.2 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/I/O-M odule/Parametri erung 767- xxxx allgemei n - Bild @ 5\mod_1249377954171_21.doc x @ 40275 @ @ 1
Figure 18: Example of an open DTM, including parameters
Pos : 30.3 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Description
Reads and displays the parameters found in the module.
Writes the modified values to the module.
Closes the parameterization user interface (DTM).
Applies the entries in the project. Please note that the project
should also be subsequently saved (File > Save).
Opens the online help for an entry that has been previously
selected in the DTM (e.g., digital inputs, global setting).
Shows/hides parameter overview.
Displays the product data sheet. A PDF reader must be
installed on your PC.
Opens the DTM online help.
WAGO-SPEEDWAY 767
767-6402 4 AI RTD
Manual
Version 3.1.0