System - ABB ACQ580 Firmware Manual

No. Name/Value
95.15 Special HW
settings
Bit Name
0 EX motor
1 ABB Sine filter
2...15 Reserved
00000000h...
FFFFFFFFh
95.20 HW options word 1
Bit Name
0 Supply frequency
60 Hz
1...12 Reserved
12 du/dt filter
activation
14...15 Reserved
0000h...FFFFh
96

96 System

96.01 Language
Not selected
English
Deutsch
Italiano
Español
Français
Suomi
Description
Contains hardware-related settings that can be enabled and
disabled by toggling the specific bits.
Note: The installation of the hardware specified by this
parameter may require derating of drive output, or impose
other limitations. Refer to the hardware manual of the drive.
Information
1 = An ABB sine filter is connected to the output of the drive.
Hardware options configuration word.
Specifies hardware-related options that require differentiated
parameter defaults.
This parameter is not affected by a parameter restore.
Value
See section Differences in the default values between 50 Hz and
60 Hz supply frequency settings
0 = 50 Hz.
1 = 60 Hz.
When active, an external du/dt filter is connected to the drive/inverter
output. The setting will limit the output switching frequency, and
force the fan of the drive/inverter module to full speed.
0 = du/dt filter inactive.
1 = du/dt filter active.
Hardware options configuration word.
Language selection; access levels; macro selection;
parameter save and restore; control unit reboot; user
parameter sets; unit selection.
Selects the language of the parameter interface and other
displayed information when viewed on the control panel.
Notes:
• Not all languages listed below are necessarily supported.
• This parameter does not affect the languages visible in the
Drive composer PC tool. (Those are specified under View -
Settings - Drive default language.)
None.
English.
German.
Italian.
Spanish.
French.
Finnish.
Parameters 281
Def/FbEq16
1 = 1
on page 298.
1 = 1
Not selected
0
1033
1031
1040
3082
1036
1035