System Info - ABB ACQ580 Firmware Manual

116 Parameters
No. Name/Value
True
Other [bit]
07

07 System info

07.03 Drive rating id
07.04 Firmware name
07.05 Firmware version
07.06 Loading package
name
07.07 Loading package
version
07.11 Cpu usage
0...100%
07.25 Customization
package name
07.26 Customization
package version
07.30 Adaptive program
status
Bit Name
0 Initialized
1 Editing
2 Edit done
3 Running
4...13 Reserved
14 State changing
15 Faulted
0000h...FFFFh
07.31 AP sequence state
0...20
Description
1.
Source selection (see Terms and abbreviations
Drive hardware and firmware information.
All parameters in this group are read-only.
Type of the drive. (Rating ID in brackets.)
Firmware identification.
Version number of the firmware.
Name of the firmware loading package.
Version number of the firmware loading package.
Microprocessor load in percent.
Microprocessor load.
First five ASCII letters of the name given to the customization
package. The full name is visible under System info on the
control panel or the Drive composer PC tool.
_N/A_ = None.
Customization package version number. Also visible under
System info on the control panel or the Drive composer PC
tool.
Shows the status of the adaptive program.
See section Adaptive programming
Description
1 = Adaptive program initialized
1 = Adaptive program is being edited
1 = Editing of adaptive program finished
1 = Adaptive program running
1 = State change in progress in adaptive programming engine
1 = Error in adaptive program
Adaptive program status.
Shows the number of the active state of the sequence
program part of the adaptive program (AP). If adaptive
programming is not running, or it does not contain a
sequence program, the parameter is zero.
on page 100). -
(page 43).
Def/FbEq16
1
-
-
-
-
-
-
1 = 1%
-
-
-
1 = 1
1 = 1