ABB ACQ580 Firmware Manual page 371

Fieldbus control through the embedded fieldbus interface (EFB) 367
Parameter
20.06 Ext2
commands
SPEED REFERENCE SELECTION
22.11 Ext1 speed ref1 EFB ref1
22.18 Ext2 speed ref1 EFB ref1
FREQUENCY REFERENCE SELECTION
28.11 Ext1 frequency
ref1
28.15 Ext2 frequency
ref1
OTHER SELECTIONS
EFB references can be selected as the source at virtually any signal selector parameter by
selecting Other, then either
SYSTEM CONTROL INPUTS
96.07 Parameter save
manually
Setting for
fieldbus control
Embedded fieldbus
EFB ref1
EFB ref1
03.09 EFB reference 1
Save (reverts to
Done)
Function/Information
Selects fieldbus as the source for the start
and stop commands when EXT2 is selected
as the active control location.
Selects a reference received through the
embedded fieldbus interface as speed
reference 1.
Selects a reference received through the
embedded fieldbus interface as speed
reference 2.
Selects a reference received through the
embedded fieldbus interface as frequency
reference 1.
Selects a reference received through the
embedded fieldbus interface as frequency
reference 2.
or 03.10 EFB reference
Saves parameter value changes (including
those made through fieldbus control) to
permanent memory.
2.