ABB ACQ580 Firmware Manual page 116

112 Parameters
No. Name/Value
06.16 Drive status word 1
Bit Name
0 Enabled
1 Inhibited
2 DC charged
3 Ready to start
4 Following
reference
5 Started
6 Modulating
7 Limiting
8 Local control
9 Network control
10 Ext1 active
11 Ext2 active
12 Reserved
13 Start request
14...15 Reserved
0000h...FFFFh
06.17 Drive status word 2
Bit Name
0 Identification run done 1 = Motor identification (ID) run has been performed
1 Magnetized
2 Reserved
3 Speed control
4 Reserved
5 Safe reference active
6 Last speed active
7 Loss of reference
8 Emergency stop failed 1 = Emergency stop failed (see parameters
9...12 Reserved
13 Start delay active
14...15 Reserved
0000h...FFFFh
Description
Drive status word 1.
This parameter is read-only.
Description
1 = If Run permissive (par. 20.40) and start interlock signals (par.
20.41...20.44) signals are all present.
Note: This bit is not affected by the presence of a fault.
1 = Start inhibited. To start the drive, the inhibiting signal (see par.
06.18) must be removed and the start signal cycled.
1 = DC circuit has been charged
1 = Drive is ready to receive a start command
1 = Drive is ready to follow given reference
1 = Drive has been started
1 = Drive is modulating (output stage is being controlled)
1 = Any operating limit (speed, torque, etc.) is active
1 = Drive is in local control
1 = Drive is in network control
1 = Control location EXT1 active
1 = Control location EXT2 active
1 = If Start requested. 0 = When Run permissive signal (see par.
20.40) is 0.
Drive status word 1.
Drive status word 2.
This parameter is read-only.
Description
1 = The motor has been magnetized
1 = Speed control mode active
1 = A "safe" reference is applied by functions such as
parameters 49.05
1 = A "last speed" reference is applied by functions such as
parameters 49.05
1 = Reference signal lost
1 = Start delay (par. 21.22) active.
Drive status word 2.
(see page 11).
and 50.02
and 50.02
Def/FbEq16
-
1 = 1
-
31.32 and 31.33)
1 = 1