ABB ACQ580 Firmware Manual page 237

No. Name/Value
45.07 Saved amount
0.00...
21474830.08 units
45.08 CO2 reduction in
kilotons
0...65535 metric
kilotons
45.09 CO2 reduction in
tons
0.0...999.9 metric
tons
45.10 Total saved CO2
0.0...214748300.8
metric tons
45.11 Energy optimizer
Disable
Enable
Description
Monetary savings compared to direct-on-line motor
connection. This value is a calculated by multiplying the
saved energy in kWh by the currently active energy tariff
(45.14 Tariff selection).
If you have not set the currency during the first start-up, you
can specify it in Main menu - Primary settings - Clock,
region display - Units - Currency.
This parameter is read-only (see parameter
calculations reset).
Monetary savings.
Reduction in CO emissions in metric kilotons compared to
2
direct-on-line motor connection. This value is incremented
when parameter 45.09 CO2 reduction in tons
This parameter is read-only (see parameter
calculations reset).
Reduction in CO emissions in metric kilotons.
2
Reduction in CO emissions in metric tons compared to
2
direct-on-line motor connection. This value is calculated by
multiplying the saved energy in MWh by the value of
parameter 45.18 CO2 conversion factor
metric tons/MWh).
When this parameter rolls over, parameter
reduction in kilotons is incremented.
This parameter is read-only (see parameter
calculations reset).
Reduction in CO emissions in metric tons.
2
Reduction in CO emissions in metric tons compared to
2
direct-on-line motor connection. This value is calculated by
multiplying the saved energy in MWh by the value of
parameter 45.18 CO2 conversion factor
metric tons/MWh).
This parameter is read-only (see parameter
calculations reset).
Reduction in CO emissions in metric tons.
2
Enables/disables the energy optimization function. The
function optimizes the motor flux so that total energy
consumption and motor noise level are reduced when the
drive operates below the nominal load. The total efficiency
(motor and drive) can be improved by 1...20% depending on
load torque and speed.
Note: With a permanent magnet motor and a synchronous
reluctance motor, energy optimization is always enabled
regardless of this parameter.
Energy optimization disabled.
Energy optimization enabled.
Parameters 233
Def/FbEq16
-
45.21 Energy
1 = 1 unit
-
rolls over.
45.21 Energy
1 = 1 metric
kiloton
-
(by default, 0.5
45.08 CO2
45.21 Energy
1 = 1 metric
ton
-
(by default, 0.5
45.21 Energy
1 = 1 metric
ton
Enable
0
1